Vectronics PM-30UV Bedienungsanleitung PDF herunterladen (Seite 2)

PM-30UV SWR/Power Meter Owner's Manual

REAR PANEL CONNECTIONS

RF OUTPUT........................................ SO-239 connector (PM-30UV)

N-connector (PM-30UVN)

BNC connector (PM-30UVB)

RF INPUT............................................SO-239 connector (PM-30UV)

N-connector (PM-30UVN)

BNC connector (PM-30UVB)

POWER................................................2.5mm coaxial type jack

INSTALLATION

1. Connect the RF INPUT to the transmitter using the appropriate

connectors. If using an antenna tuner, the PM-30UV should be

placed between the transmitter and antenna tuner.

2. Connect the RF OUTPUT to the antenna using the appropriate

connector. If using an antenna tuner, the RF OUTPUT is connected

to the antenna tuner input.

Note

: Vectronics recommends using high quality cable for all

connections.

3. If a lighted meter is desired, a 9-12Vdc power supply, such as the

Vectronics AC-12, must be connected to the jack labeled POWER on

the back of the unit. This is a 2.5mm coaxial type jack with the

center positive.

OPERATION

1. Set the PM-30UV to the proper band by pressing the appropriate

switch (144/220/440). To more accurately display RF power

in the amateur bands that lie in the 100-500 MHz range, is the

reason 144, 220, and 440 option switches are provided on the

front panel. This wattmeter is, however, usable at frequencies other

than the 3 front panel option ranges. See the CALIBRATION

section for more information.

1 2 3 4 5 6

Keine Kommentare

Vectronics PM-30UV Bedienungsanleitung Seite 2